Holybro PM06 V2 10S Micro Power Module with XT60 Connector for RC Drone
Introduction:This PM06 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated power distribution for 4 ESCs. It comes with pre-soldered wires, capacitor, and XT60 connector.Specification:Input voltage: 2S-10SPCB Cont. Current Rating: 70APCB Burst Current Rating: 120A (<60 Sec)Output: DC 5.2V & 3A Max Ouput Max Power : 18WVoltage Divider: 18.182Amperes per Volt: 36.364 Please Note: - The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference. - This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D). Mechanical Specification:Dimensions: 35x35x5mmMounting hole: 30.5mm*30.5mmWeight: 24gSetup guide for PX4 & Ardupilot can be found in the Holybro Doc here.Package Included:1x PM06 board1x 80mm XT60 connector wire (pre-soldered)1x Electrolytic capacito: 220uF 63V (pre-soldered)1x JST GH 6pin cable
🟢 In Stock
✔️ WORLDWIDE SHIPPING
✔️ 30 DAYS RETURN GUARANTEE
✔️ SECURE CHECKOUT
Introduction:
This PM06 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated power distribution for 4 ESCs. It comes with pre-soldered wires, capacitor, and XT60 connector.
Specification:
Input voltage: 2S-10S
PCB Cont. Current Rating: 70A
PCB Burst Current Rating: 120A (<60 Sec)
Output: DC 5.2V & 3A Max
Ouput Max Power : 18W
Voltage Divider: 18.182
Amperes per Volt: 36.364
Please Note:
- The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference.
- This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D).
Mechanical Specification:
Dimensions: 35x35x5mm
Mounting hole: 30.5mm*30.5mm
Weight: 24g
Setup guide for PX4 & Ardupilot can be found in the Holybro Doc here.
Package Included:
1x PM06 board
1x 80mm XT60 connector wire (pre-soldered)
1x Electrolytic capacito: 220uF 63V (pre-soldered)
1x JST GH 6pin cable
